Axial SCX-10 Precision Tie Rod, Aluminum Upgrade for Improved Steering - ASCX10-22403-02-S by Jazrider  [ASCX10-22403-02-S]

Axial Racing SCX-10 Aluminum Steering Linkage (Silver)
Price:
NZD$11.75
Brand:
JAZRIDER
Model:
ASCX10-22403-02-S
Condition:
Brand New
Available in shop
Write a review

Precision Tie Rod for SCX-10 Crawlers

This steering linkage is made for Axial SCX-10 chassis applications and comes in a silver anodized aluminum finish. Model ASCX10-22403-02-S replaces original plastic or distorted links to re-establish correct steering geometry in scale rock crawlers.

Fitting follows standard tie-rod replacement steps: remove the existing link, inspect rod ends and ball cups for wear, install the new aluminum link and secure to the correct thread engagement. Typical hand tools such as hex keys and small spanners are sufficient. After installation, check for interference with the servo horn and full suspension travel.

As an upgrade, the aluminum tie rod offers better dimensional stability and repeatable toe under load, which benefits consistent tracking during extended crawling sessions. Note that servo tuning and link length adjustments remain important for final handling.

How does aluminum hold up versus stock plastic?

Aluminum offers greater resistance to bending and wear compared with typical plastic links, giving longer service life under repeated load. However, check for impact damage after heavy hits.

Should I use corrosion protection on the link?

Anodized finishes provide corrosion resistance; if you operate in salt or wet conditions, rinse and dry components after use to extend life.

Is the part serviceable if rod ends wear?

Inspect rod ends periodically; worn ends can be replaced or upgraded. The link itself is dimensionally stable, but end fittings are wear items depending on use.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved