Axial SCX10 Steel Main Shaft Set SSCX037 by GPM  [SSCX037]

Core role and build

This 1pr steel main shaft set is supplied as a matched pair designed for Axial Racing platforms, aimed at servicing the driveline and axle internals on scale rock crawlers and trail rigs. Built in steel, the pair restores original axle geometry where a direct-fit replacement is required.

Functionally the shaft secures gears and bearings, keeps axle alignment intact, and transmits drive torque through the axle housing. When replacing shafts, confirm correct orientation and secure bearing seating before final reassembly to reduce the risk of accelerated wear on mating components.

Fitting tips: take the axle apart carefully, label shims and spacers, inspect 走珠軸承 for wear or roughness, and tighten fasteners to the chassis maker's recommended torque. A light smear of oil on splines helps assembly but avoid over-lubrication that could trap dirt.

Maintenance note: SSCX037 is a service replacement rather than a performance upgrade; fit it to reinstate factory geometry or to replace damaged shafts after impacts, and check spline and bearing-seat condition during regular servicing.

Use this matched pair when you want a reliable, scale-correct shaft replacement for Axial SCX10 and Wraith axles, keeping driveline alignment stable for ongoing use.