Axial SCX6 1/6 Aluminum Front Steering Knuckles JR-SCX601-TI Upgrade for precise steering by Jazrider  [JR-SCX601-TI]

Upgraded front knuckles for SCX6 Jeeps

This replacement kit is an RC-scale front steering knuckle set made for Axial 1/6 SCX6 Jeep variants. Constructed from aluminum with a titanium-style surface, the parts are intended to substitute plastic originals when reduced flex and consistent wear characteristics are desired.

Fit intent: the components align with the front axle layout of the Axial SCX6 platform and act as direct-swap items for the steering knuckle positions. Once fitted they alter steering stiffness and load response in predictable ways, helping with fine adjustments to servo centering, travel limits, and suspension tuning to reach target handling.

Fitting advice: remove the OEM knuckles and inspect pivot points, bearing seats and link mount locations before finalising installation. Make sure wheel hubs spin freely across the full suspension stroke and re-check steering trim after assembly to correct any geometry changes introduced by the metal parts.

Choose these knuckles when you want metal replacements that stabilise steering inputs and allow progressive tuning of steering and suspension on Axial SCX6 1/6 scale rigs.