Axial SCX6 Aluminum Rear Bumper Mount - JR-SCX606-TI (Titanium) by Jazrider  [JR-SCX606-TI]

Axial 1/6 SCX6 Jeep Aluminum Rear Bumper Mount (Titianum)
Price:
NZD$35.92
Brand:
JAZRIDER
Model:
JR-SCX606-TI
Condition:
Brand New
Available in shop
Write a review

Construction and Fit Notes

This RC-scale rear bumper mount was produced for the Axial 1/6 SCX6 Jeep chassis and is provided under part number JR-SCX606-TI. It creates a secure attachment point for a rear bumper or accessories on the SCX6 JLU Wrangler 4WD rear section.

The mount is intended as a structural replacement rather than a trim clip; fitment uses the chassis' existing mounting locations with common fasteners. It suits builders who need a metal option for accessory mounting or to replace the stock plastic bracket on an SCX6.

Check clearance against the body shell and any rear gear before final assembly. Because bumper loads transfer into the chassis, inspect fastener torque and ensure there is no contact with suspension or electronic components following installation. This item is for RC model use only.

Specifications

  • Item: Rear bumper mount
  • Material: Aluminum (Titianum)
  • Model Number: JR-SCX606-TI
  • Compatibility: Axial SCX6 Jeep JLU Wrangler 4WD

For those rebuilding or upgrading SCX6 rears, model JR-SCX606-TI provides a metal mounting solution that emphasises strength and reliable accessory fitment for the Axial 1/6 Jeep chassis.

How resilient is the mount material to impacts?

The part is made from aluminum (Titianum), offering greater rigidity than typical plastic brackets. It improves resistance to deformation under load but will still transmit impact forces into mounting points, so inspect for cracks after heavy hits.

Does the finish resist corrosion for coastal running?

Aluminum has good natural corrosion resistance, but exposure to salt or persistent moisture requires rinsing and periodic inspection. Apply routine maintenance after runs near saltwater to prolong surface condition.

Is this mount prone to fatigue over time?

With correct installation and proper fastener torque, aluminum mounts generally offer long service life. Check mounting points periodically for loosening or stress signs, especially after heavy use.

Will the part fit a modified SCX6 chassis?

The mount is intended for Axial SCX6 Jeep JLU Wrangler 4WD mounting locations; minor body or bumper modifications may be needed for heavily modified chassis or non-standard accessories. Confirm clearances before final drilling or trimming.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved