Axial SCX6 Front and Rear CVD Drive Shaft Upgrade SCX6037S by GPM  [SCX6037S]

Robust CVD drive shafts for SCX6 scale rigs

This is a scale-compatible front and rear CVD drive shaft set intended for AXIAL SCX6 JEEP JLU WRANGLER 4WD models. The 6 piece assembly services both front and rear axles and includes the necessary screw pins for mounting. It is an aftermarket replacement part that matches typical SCX6 driveline arrangements, model SCX6037S.

Made from carbon steel, these CVD (constant velocity drive) components transfer drive torque into the axle assemblies while handling increased stress. The CVD configuration offers better load handling and permits larger transmission angles than basic dogbone shafts, which benefits rigs running heavy articulation or steep obstacles.

Installation involves removing the original shafts from the axle cups and fitting the new CVD units using the supplied screw pins. Check that pins are correctly seated, do not over-tighten fasteners, and verify the shafts rotate freely through the full suspension travel before finishing the job.

Ideal for replacing fatigued drive parts or upgrading driveline robustness on SCX6-based crawlers where extra strength and angle tolerance are needed.