Axial SCX6 Front Upper Shock Tower — Precision Aluminum JR-SCX603-TI by Jazrider  [JR-SCX603-TI]

Front upper shock tower tailored to Axial SCX6

This RC-scale front shock tower is built for use with the Axial 1/6 SCX6 Jeep chassis. It replaces the original front upper mounting location to deliver a more rigid and consistent shock attachment point. The item is shown as an aluminum component and intended for hobby-scale trail setups.

Installation notes: the tower matches the SCX6 front mounting pattern. In most cases you will reuse the vehicle's existing shock and tower screws, but have a hex driver and metric socket set ready. After installation, inspect the steering and shock shafts to ensure nothing binds.

Tuning role: installing this tower changes front mount stiffness and can influence shock angle and leverage. That in turn affects damping feel and perceived spring rate, so adjust spring and damper settings as part of setup work.

On SCX6-based scale trail builds this tower is a straightforward upgrade to stiffen front shock mounts and tune handling; always check fitment against your SCX6 JLU Wrangler chassis before installing.