Axial SCX6 Scale Front Mount JR-SCX605-TI for 1/6 Jeep by Jazrider  [JR-SCX605-TI]

Axial 1/6 SCX6 Jeep Aluminum Front Bumper Mount (Titianum)
Price:
NZD$35.92
Brand:
JAZRIDER
Model:
JR-SCX605-TI
Condition:
Brand New
Available in shop
Write a review

Scale Front Mount for SCX6 Jeeps

This is an RC-scale front bumper mounting component designed for the Axial 1/6 SCX6 Jeep platform and listed as model JR-SCX605-TI. The piece is machined from aluminum and carries a Titianum finish, intended to serve as a direct bumper mount or reinforcement point on SCX6 scale projects.

In service the mount provides a secure anchor for the bumper assembly and helps resist deformation under load during trail use. The emphasis is on structural integrity and fit rather than decorative trim, suitable for modelers who want a metal upgrade over stock plastic mounts or a stable base for accessory bumpers and recovery points.

Installation notes: designed to line up with SCX6 front mounting locations; typical RC hand tools such as hex drivers should be adequate. Confirm existing bumper fastener sizes and hole locations before installing, and apply thread-lock or lock washers when fastening metal parts together.

Specifications

  • Item: Axial 1/6 SCX6 Jeep Aluminum Front Bumper Mount (Titianum)
  • Material: Aluminum
  • Model Number: JR-SCX605-TI
  • Compatibility: Axial SCX6 Jeep JLU Wrangler 4WD

For enthusiasts building scale SCX6 rigs, this aluminum front bumper mount supplies a durable, straightforward upgrade option to improve front-end stiffness and mounting reliability.

Will this mount cope with hard trail use?

Aluminum adds rigidity compared with plastic mounts and should better withstand repeated loading, but longevity depends on installation quality and the severity of trail conditions.

Does the Titianum finish protect the metal?

The finish provides a scale look and added surface protection; it is not a guarantee against corrosion, so check care recommendations for aluminum finishes and avoid harsh chemicals.

Any prep required before fitting?

Inspect and, if needed, clean or deburr the chassis mounting points, check hole alignment, and choose the correct fastener sizes; use thread-lock for metal-to-metal joints where appropriate.

Can it replace the stock plastic mount directly?

If your SCX6 front mounting points match the part's layout, this aluminum mount can serve as a direct replacement; confirm fit before committing to installation.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved