Axial Wraith Drive Shaft Set SWR037 by GPM  [SWR037]

Main shaft replacement for Wraith drivetrains

This hardened steel main shaft set is intended as a direct replacement for the Axial Racing Wraith drivetrain and is provided as a pair for routine repairs and tuning. The components focus on restoring alignment where original shafts have bent or worn.

Made from hardened steel to resist bending under trail and rock-crawling loads, these shafts require verification of seating inside the gearbox and hub bores. Also confirm adequate clearance with the spur gear and bearings to prevent binding after installation.

Installation guidance: remove the drivetrain to inspect related bearings and retaining hardware, install each shaft in the correct orientation, and check for smooth manual rotation before completing reassembly. Consider these shafts a standard wear item when servicing the transmission.

Fit this set when correcting drivetrain geometry or replacing worn transmission pieces on Axial Wraith models, and match other drivetrain components during service.