This 2pcs set contains front and rear bevel gears manufactured in steel and intended for use on the Axial Racing Wraith platform as aftermarket replacements. The set is aimed at builders who favour steel durability over stock materials in demanding trail conditions.
Installation tips: the parts are specified for Wraith axle and differential areas named in the title and require disassembly of the differential/gearbox to install. After fitting, adjust gear mesh and check for interference, and examine nearby bearings since a harder gear material can alter load distribution.
Use case: steel bevel gears are commonly added to rigs used for low-speed, torque-heavy tasks such as rock crawling. They extend wear life of gear teeth but depend on correct lubrication and healthy bearings to deliver reliable service.
Fit these when you want tougher gear teeth for crawling and trails, and perform mesh checks and bearing inspections as part of the swap.
Copyright © 2008-2026 rcjaz.co.nz All rights reserved
