This 2-piece aluminium steering link replaces the factory plastic rods on Axial Wraith models to limit flex at the steering end and maintain a more direct connection between the servo horn and steering knuckles.
The finished aluminium parts prioritise strength and low mass to suit common Wraith setups, and they are matched as a pair to preserve symmetric steering geometry during replacement of both sides.
Fitting is simple for anyone familiar with basic servo and steering work: remove the originals, verify rod-end and ball stud compatibility, fit the aluminium links and check free movement throughout suspension travel. Avoid over-tightening to prevent binding in the joints.
On-track tuning: swapping to aluminium links reduces unwanted compliance under load, helping steering inputs remain consistent during aggressive driving and while dialling in servo endpoints or steering rates. Measure tie-rod length and toe after installation to keep handling predictable.
Copyright © 2008-2026 rcjaz.co.nz All rights reserved
