Axial Yeti +10mm Delrin Hex Wideners DYT010/+10MM by GPM  [DYT010/+10MM]

Delrin hex wideners tailored for Yeti hubs

These RC hex spacers are produced for the Axial Racing Yeti platform and supplied as a pair in Delrin with a +10mm profile to push wheel offset outward. They are intended to change track width and clearance for model use only.

Each widener moves the wheel mounting face 10mm outward on the hub, which affects tyre clearance, potential contact with suspension or bodywork, and the chassis handling balance. Use them to tune cornering behaviour or to stop aftermarket tyres or wider beadlocks from rubbing the body.

Installation on the Yeti hex system is straightforward: remove the wheel and current hex, position the Delrin widener on the hub, then reinstall the wheel and keepers with the original hardware. Verify wheel centring and thread engagement, then check for any interference after fitting.