Axial Yeti Differential Housing Cover, Machined Aluminum - AW-23032-BK by Jazrider  [AW-23032-BK]

Yeti Differential Cover — Precision Aluminum

This aluminum differential cover is made for the Axial Yeti chassis as a direct replacement for the factory plastic cover, offering a metal alternative for pilots focused on long-term durability and chassis tuning. The item comes in a black finish and is offered as a single piece to upgrade the differential housing.

The cover provides impact and abrasion protection for the differential case during rock crawling and trail runs, and supplies a firmer mounting face that some modelers use to refine driveline response. Expect some increase in mass at the axle as a trade-off, which can influence suspension and handling choices when setting up the vehicle.

Installation guidance: the cover locates to the Yeti differential housing and is intended to be installed in place of the OEM cover using existing mounting interfaces and screws. Basic hand tools, such as a hex driver, are normally sufficient. Verify fastener torque and thread condition and check gear mesh and bearing alignment once the unit is reassembled.