Axial Yeti Front Steering Kit Aluminium 6pcs YT048 by GPM  [YT048]

Front steering kit in aluminium for Yeti

This aftermarket steering assembly is a 6pcs aluminium replacement set built for compatibility with the Axial Yeti chassis. It is supplied as a direct replacement for the original steering links and knuckles, intended for scale RC use only.

The kit collects the primary steering linkage parts used at the front of the Yeti, using aluminium to increase rigidity and resist abrasion better than standard plastic components. The aim is to improve steering feedback and reduce wear while keeping factory geometry intact; check fitment against your existing steering parts before finishing the build.

Fitting is routine for hobbyists familiar with the Yeti steering layout: remove the equivalent stock components, reuse any bearings or small parts as required, and fasten the aluminium pieces with the original screws. Confirm steering runs smoothly and retorque fasteners after a short test session.

Hobbyists looking to reduce flex in the front end of an Axial Yeti will find this aluminium 6pcs set a direct, durable swap; always double check hardware fit and torque levels during installation.