Axial Yeti Rear Sway Bar and Cage Mount YT312 by GPM  [YT312]

Rear sway bar and cage anchoring for Axial Yeti

This 9pcs kit addresses rear anti-roll linkage and cage attachment points used on Axial Racing Yeti models in off-road rock racing use. The items are an aluminium aftermarket mount plus wire that relocate or replace the stock sway bar and cage anchors so you can control rear roll and secure the cage tie-in.

The components are intended for hobby-level chassis work and are described as scale upgrade parts for Axial Yeti vehicles. The set concentrates on three areas: a solid mounting point for the rear sway bar, a place to attach cage wiring or supports, and small tuning adjustments to rear roll resistance while keeping suspension geometry intact.

Fitting is done at the Yeti chassis rear mount points. Typical procedure involves removing factory fasteners, fitting the aluminium mount into the original position, routing and securing the supplied wire for the cage, and checking suspension clearance during travel. Basic hand tools and a hex driver will handle the job, and it is wise to torque fasteners to spec and check for binding after assembly.

The intention is tuning and adjustment rather than major structural change. Builders use this mount to tweak rear anti-roll stiffness and to tidy up cage connections in trail and rock racing setups, with reversible installation so you can return to the original configuration if needed.

This aluminium rear sway bar and cage mount set gives a tidy aftermarket solution for Axial Yeti owners wanting controlled rear roll tuning and a dependable cage attachment while staying reversible and serviceable with common tools.