Axial Yeti Servo Tie Rod Aluminium Adjustable YT024A by GPM  [YT024A]

Adjustable servo tie rod for Axial Yeti setups

This adjustable servo tie rod is built for Axial Yeti rock racers and is sold as 1 pcs. An aluminium threaded shaft with black plastic end fittings forms a compact steering link tailored to scale rock crawling and racing.

The component replaces the stock servo-to-knuckle link and is used to tweak steering geometry. Turning the threaded section alters toe and steering throw in small steps so you can refine handling without changing major suspension parts.

Installation on compatible Yeti steering is straightforward: remove the existing linkage, verify left/right thread direction where required, and ensure both ends have adequate thread engagement. Make sure the plastic end fittings clip securely to the linkage pins and that the rod does not foul suspension travel.

For upkeep, watch the condition of plastic ends after intense use, confirm straight alignment after fitting, and make sure steering moves freely through its full range. Retighten fasteners after running.