This 5pc tie rod kit is built for Axial Racing Yeti chassis and supplied to support maintenance and rebuilds. Centre rods are spring steel for bend resistance and the ends are aluminium to connect cleanly with steering knuckles and hub carriers. Intended for hobby RC applications.
The part serves to replace worn tie rods and restore correct steering geometry while maintaining secure thread engagement, helping to prevent stripped rod ends. It targets Axial Yeti style chassis; measure your linkage lengths and end fittings to ensure a match before installing. Use this set when refreshing steering components or when fine-tuning steering behaviour.
Installation follows standard linkage procedures: remove wheel, expose steering links, confirm lengths, move over ball cups or set turnbuckle lengths to match the original geometry, then tighten hardware to appropriate torque. Check ball cups and servo-saver interfaces for wear while you fit the new rods for a complete steering repair.
Use these when refreshing steering components or when experimenting with small geometry changes on Axial Yeti rigs; confirm fitment and secure all fasteners before use.
Copyright © 2008-2026 rcjaz.co.nz All rights reserved
