Axial Yeti Steering Link Upgrade Anti-thread Rods YT160P by GPM  [YT160P]

Axial Racing Yeti Spring Steel Completed Anti-thread Tie Rod With Black Plastic Ends - 5pcs set (AX80119) - GPM YT160P
Price:
NZD$22.11
Brand:
GPM
Model:
YT160P
GTIN:
4894538242294
Condition:
Brand New
Available in shop
Write a review
alt="Axial Racing Yeti Spring Steel Completed Anti-thread Tie Rod With Black Plastic Ends - 5pcs set (AX80119) - GPM YT160P" title="Axial Racing Yeti Spring Steel Completed Anti-thread Tie Rod With Black Plastic Ends - 5pcs set (AX80119) - GPM YT160P"

Steering link upgrade for Yeti

This five piece set of spring steel anti-thread tie rods is supplied for Axial Yeti platforms with black plastic ball ends. The links arrive ready to fit and replace worn or damaged steering rods without altering servo mounting or steering geometry.

Installation is the usual link swap: remove the original tie rod, insert the spring steel rod end into the existing ball cup, check correct thread engagement and alignment, then secure. The polymer ends cut down on direct metal contact at the joint and keep installation straightforward.

The component aims to reduce thread wear during rock crawling and hard trail use while preserving original link geometry so steering response and servo effort remain consistent with longer service life.

What benefit does anti-thread give my steering?

Anti-thread construction uses spring steel for strength and plastic ball ends to protect threads and joint surfaces from accelerated wear.

Are any other parts required to fit these?

No additional parts are normally required; the set is intended to use the Yeti's existing ball cups and mounting hardware for a direct installation.

How often should I check them?

Check threads and ball ends after a few runs and during regular servicing; tighten and replace items if wear or bending is noticed.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved