Axial Yeti / Yeti XL 18T 32 Pitch Steel Pinion YT018TS for Tuning by GPM  [YT018TS]

Aftermarket pinion for Yeti range

This single 32 pitch, 18-tooth steel pinion is produced for Axial Racing Yeti and Yeti XL platforms and is supplied under model YT018TS. It provides a tougher motor pinion option for off-road trail and rock racer drivetrains where frequent gearing adjustments are part of setup work.

Key practical notes:

• Material and form: steel #45 construction chosen for its wear resistance versus softer materials, provided as a 1 pcs set for straightforward replacement.
• Compatibility: designed to fit Axial Racing Yeti and Yeti XL motor pinion mounts that accept 32 pitch 18T gears; check shaft diameter and set-screw alignment before installation.
• Installation tips: set gear mesh carefully against the spur gear, tighten the set-screw without over-torqueing, and verify there is no endplay or bearing bind after fitting.
• Tuning role: swapping to an 18T changes gearing and motor load; use it when you want more torque or altered top-speed behaviour on technical lines.