Axial Yeti XL Rear Lower Link Upgrade for Chassis - YTL-25008A by Jazrider  [YTL-25008A]

Axial Yeti XL Aluminum Rear Lower Chassis Link
Price:
NZD$27.38
Brand:
JAZRIDER
Model:
YTL-25008A
Condition:
Brand New
Write a review

Rear Lower Chassis Link for Axial Yeti XL

This is an RC-scale rear lower chassis link designed for Axial Yeti XL platforms, supplied under JAZRIDER model YTL-25008A. The component substitutes the stock rear lower link to recover correct suspension geometry after wear or impact, and it provides a reliable reference when tuning rear roll center and toe settings.

Produced in aluminum, the link is a firmer option than original plastic items, reducing unwanted movement under load. Confirm compatibility with your specific Axial Yeti XL chassis layout before ordering.

Installation guidance: extract the broken link and fit the JAZRIDER replacement using the existing chassis fasteners, check thread engagement and clearance while refitting, and inspect suspension travel and steering after installation. Standard Yeti XL setups do not normally require modifications.

Specifications

  • Item Rear lower chassis link
  • Material Aluminum
  • Model Number YTL-25008A
  • Compatibility Axial Yeti XL

Fit this aluminium link to preserve rear suspension geometry on Yeti XL models and to replace failed stock components with a more rigid option.

What tools are required to swap the rear lower link?

Basic hand tools such as the correct-size hex drivers or sockets that match your chassis fasteners are sufficient. Use a calm work surface and keep track of small washers and screws.

Should I use threadlocker when fitting this link?

Light use of a removable threadlocker can help prevent fasteners loosening under vibration; avoid permanent threadlockers if you expect to remove the part frequently.

Do I need to re-check suspension geometry after installation?

Yes. After fitting, verify suspension travel, toe, and roll centre settings to ensure the replacement is performing as expected within your setup.

Can I pair this with upgraded rod ends or link hardware?

The part uses standard mounting points for Yeti XL; higher-spec rod ends can be used if their dimensions match the chassis, but confirm clearance and thread compatibility first.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved