Bandai 5074254 30MM Water-slide Decals for 30 Minutes Missions  [B-5074254]

Fine transfer decals tailored for 30MM models

This water-slide decal pack is presented as an aftermarket detailing accessory for the Bandai 30 Minutes Missions 30MM series, made to add precise surface graphics and insignia to plastic figures and frames.

Application and fit

The transfer film uses a water-release process suited to smooth model surfaces. Trim close to each marking and control the carrier film during placement; applying a setting solution will help the decal sit into curves and recessed lines found on many 30MM parts. Light scuffing of the topcoat at joints can improve fit.

Surface preparation and finishing

Clean the model of any release agent and use a glossy base where decals will go to cut down on silvering. Once transferred and dry, a clearcoat is recommended to lock the decal in and harmonize texture with the surrounding paint. Avoid harsh rubbing over printed areas to retain fine print detail.

Builder considerations

Intended for modellers comfortable with water-slide techniques. Work with tweezers and magnification for small symbols and minimise leftover carrier film to prevent lifting. Apply seam and fill work before decal placement to avoid highlighting imperfections.

Display value

Correctly applied and sealed, these decals add small graphic fidelity that is hard to match by brushwork alone, improving the model at viewing distance. Accurate alignment and suitable topcoating are critical for best results.

A convenient option for adding crisp markings to 30 Minutes Missions kits; requires standard water-slide care, planned surface prep, and a finishing clearcoat for long-term display quality.