Tamiya 22068 BB-01 63mm Dogbone Shafts - Carbon Tool Steel Pair  [22068]

Tamiya 22068 - BB-01 Dogbone Shafts/Swing Shafts 63mm (2Pcs) OP-2068
Price:
NZD$23.06
Brand:
Tamiya
Model:
22068
GTIN:
4950344220687
Condition:
Brand New
Available in warehouse
1 Reviews
Write a review

Heavy-duty drive shafts for BB-01 rigs

The Tamiya 22068 - BB-01 Dogbone Shafts deliver a sturdy replacement for worn drive parts. Constructed from carbon tool steel and cut to 63mm, these components are intended to extend service life during demanding use.

Why pick carbon tool steel dogbones

Carbon tool steel is chosen for its toughness and ability to resist deformation. For club racers and trail riders who push their BB-01 chassis hard, these shafts offer a sensible upgrade to lower maintenance frequency.

Compatibility notes and simple install

Engineered for BB-01 platforms, the shafts fit as direct replacements in most setups. Installation is simple and uses standard workshop tools so you can replace them without lengthy disassembly.

 

Product Reviews
1 Reviews
rating
Excellent service and communication for my large order, package arrived just 3 days later from 7347kms away speedy delivery 👍

Are the 63mm length and ends the same as original?

The 63mm length matches common BB-01 shafts. Check the end fitting on your car to confirm the part interfaces correctly with your cups and drive cups.

Will these reduce drivetrain maintenance?

Their greater wear resistance helps reduce how often you replace shafts, though routine checks and lubrication of related components remain important.

Can I use these with hopped-up BB-01 engines?

Yes. They are suited to BB-01 cars with moderate power upgrades, but always inspect mating parts for wear when increasing motor output.

How should I care for these shafts?

Keep the drive cups and bearings clean and lightly lubricated. Replace shafts if you spot excessive wear or bends after heavy impacts.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved