BD7-2014 Replacement M2 x 5mm Cap Screws, 3.2mm Head - YOKZC-C25M Yokomo  [YOKZC-C25M]

Yokomo ZC-C25M - M2 x 5mm Cap Screw (3.2mm Head/8pcs) for BD7-2014
Price:
NZD$9.45
Brand:
Yokomo
Model:
YOKZC-C25M
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

M2 x 5mm Screws — BD7-2014 Fitment

The Yokomo YOKZC-C25M is provided as a small replacement hardware set for the BD7-2014 touring chassis. Each packet contains eight M2 x 5mm hex socket cap screws with a 3.2mm head diameter as named in the product title, suitable for replacing lost or worn fasteners on suspension mounts and chassis points.

To install, align the screw with the mating threaded hole, push the head flush to the surface, and tighten using an M2 hex driver of the correct size. Confirm proper thread engagement and alignment during fitting to avoid cross-threading. For routine upkeep, inspect screws for head deformation or thread damage and replace the set to preserve firm mounting and minimise unwanted movement in linkages.

Included in the pack

  • M2 x 5mm cap screw (3.2mm head) - 8 pcs

Fits

  • BD7-2014
Remark :
Due to limited stock availability, please notice that some Yokomo items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

What tightening torque is appropriate for these M2 screws?

There is no specific torque listed; use a small hex driver and apply moderate, controlled torque so the head seats flush without over-tightening or stripping the thread.

Will these fit other 1/10 touring cars?

These are sized M2 x 5mm with a 3.2mm head and may fit other models that use the same hardware, but confirm the OEM screw size for any chassis before fitting.

How can I check thread engagement during installation?

Start the screw by hand, ensure several full turns engage cleanly, then finish with the hex driver while watching alignment to avoid cross-threading.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved