Bell Crank A Replacement for DIB Steering - Yokomo YOKIB202A (Blue)  [YOKIB202A]

The Yokomo YOKIB202A Aluminum Bell Crank A is a purpose-made RC replacement part for DIB steering systems, supplied with a blue anodized finish. It is designed to mate with existing DIB linkages and gives a rigid aluminum alternative to softer factory parts.

Functionally, this bell crank converts servo output into steering motion and provides a stable pivot that affects steering feedback and consistency. It is intended for 1/10 scale electric RC models only and must not be used on real vehicles.

Compatibility and fitment guidance

This component fits DIB-style steering geometries as indicated by the name; confirm your chassis uses the same DIB layout before fitting. The product is a single Bell Crank A unit meant to replace the matching original without changing the steering geometry when paired with matching DIB linkages.

Installation tips and tuning

• Remove the stock bell crank and transfer any usable hardware to maintain original alignment where possible.
• Check for free movement across the full steering sweep after installation to ensure no binding.
• Adjust tie-rod lengths or centering if necessary to recover neutral steering and correct any offset.
• Perform routine inspections of fasteners and pivot areas to detect wear early.

This machined aluminum bell crank is a useful upgrade for DIB steering setups where a firmer pivot and consistent geometry are desired during 1/10 scale RC handling refinement.