HPI Bullet 3.0 MT/ST Front Tyre and Alloy Beadlock Rim Set BMT1003F+889 by GPM  [BMT1003F+889]

Front tyre and beadlock upgrade for HPI Bullet 3.0

This aftermarket set supplies front rubber tyres mounted on nylon rim frames with alloy 10-pole beadlock rings, and it includes 12x9mm drive adapters for HPI Bullet 3.0 MT and ST nitro chassis. The components are intended as direct replacements to help recover steering responsiveness and permit simple front-end tuning without changing hub geometry.

To fit, remove the original front wheels, attach the 12x9mm drive adapters to the existing hex or axle interface, place the tyre on the nylon rim and secure the alloy beadlock ring with the supplied bolts. Always confirm adaptor sizing before first installation.

The beadlock design makes tyre swaps and small stagger changes straightforward while nylon rim frames help absorb impacts. The alloy 10-pole ring clamps the tyre to reduce slippage and support repeatable steering feel on varied surfaces. Perform routine checks of beadlock screws and adapter tightness after running.

Ideal for replacing worn front tyres or for trialling small setup changes on HPI Bullet 3.0 MT/ST nitro rigs; avoid over-tightening adapters to prevent hex damage and recheck beadlock bolts regularly.