Bullet Flux MT/ST Steering Upgrade Alloy 3pcs BST048 by GPM  [BST048]

HPI Bullet Flux x Mt And St Alloy Steering Assembly With Bearings - 3pcs set - GPM BST048
Price:
NZD$29.99
Brand:
GPM
Model:
BST048
Please kindly input your name and email address, we will inform you once we have the restocking.
Write a review

3-piece alloy steering assembly for Bullet Flux

This 3pcs steering assembly serves as a scale replacement for HPI Bullet Flux MT and ST vehicles and is identified as model BST048. The set bundles alloy steering links with fitted bearings into a concise 3-piece kit for those refreshing worn parts or dialing in a firmer steering setup.

Offered as a direct hardware upgrade, the aluminum alloy parts increase rigidity compared with factory plastic arms and the bearings cut friction at the joints. The kit is intended to mate with existing steering linkages and standard servo horn attachments on Bullet Flux MT and ST, and it does not contain servo or drive electronics.

Specifications

  • Item: Alloy steering assembly with bearings, 3pcs set
  • Material: Aluminum alloy
  • Model Number: BST048
  • Compatibility: HPI Bullet Flux MT and ST

For weekend racers and club technicians using Bullet Flux MT or ST, this alloy steering assembly provides a simple upgrade path to firmer steering behaviour and reduced play, fitted using standard hex tools without altering stock geometry.

Is any trimming or modification needed?

In most cases no trimming is required; the BST048 parts replace the factory link points directly. Verify clearances around tyres and shocks before final tightening.

Will this affect servo load?

Increased stiffness can slightly raise servo load under heavy impact. Use a servo with adequate torque and keep steering endpoints and travel adjusted to prevent binding.

Are the bearings sealed?

The kit includes pre-installed bearings to reduce friction; inspect them periodically and clean if you operate in dusty or wet conditions.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved