The Z4-309-8 rear belt is supplied as a replacement option for the Yokomo YZ-4 4WD off-road car. Length is 309mm with a 103T tooth count and an 8mm nominal width to match the original rear drivetrain layout.
Fit this belt when you need to restore stock geometry or replace a tired timing belt. Before installation, examine pulley grooves and drive parts for damage, route the belt on every pulley following the original pattern, and set moderate tension to eliminate slack without stressing bearings.
During setup the correct 103T, 8mm belt helps maintain steady engagement between spur and pinion and supports consistent torque transfer across the 4WD system.
Compatible with B-YZ4 chassis and the YZ-4 4WD off-road car platform.
Copyright © 2008-2026 rcjaz.co.nz All rights reserved