Carbon Tail Servo Mount for EMBLA EB - HI0304138 Hirobo  [HI0304138]

Carbon tail servo mount tailored to EMBLA EB

This HI0304138 carbon rudder servo frame from Hirobo is a light, scale-oriented replacement built for EMBLA EB series models. It creates a firm mounting point for the tail servo to enhance alignment and reduce unwanted play in the linkage without changing electronic setup.

Built as a simple external drop-in around the rudder zone, the design prioritises stiffness and low mass. The carbon material resists bending under tail loads, which supports more accurate tail inputs during hover and manoeuvres. It is aimed at routine hobby setup and tuning rather than control system modification.

Installation notes: confirm the part matches EMBLA EB airframe cutouts, fasten using the original mounting points and hardware, and inspect linkage travel before the first flight. When trimming, make small, measured adjustments to servo endpoints and linkage geometry to dial in rudder behaviour.