Carbon Wishbone Mount (Inside Front/Rear) compatible with SRX8GTR EC GP SER600077 - SER601404 Serpent  [SER601404]

Serpent SER601404 Carbon wishbone mount inside fr/rr
Price:
NZD$47.14
Brand:
Serpent
Model:
SER601404
Condition:
Brand New
Write a review

Carbon wishbone support for SRX8GTR chassis

Serpent SER601404 is a carbon-made internal wishbone support built for inside installation on the SRX8GTR EC GP SER600077 front and rear suspension arms. The part is machined from carbon plate and serves as the internal locating point that aligns the wishbone to the bulkhead and suspension layout.

Used as a direct replacement or an upgrade to the stock internal support, this mount keeps factory geometry while offering the stiffness and light weight of carbon construction. It is intended for use only on the compatible chassis listed in the specifications.

From a durability standpoint, the stiffer attachment reduces movement at the mounting point, which can lower wear from repeated flex and keep suspension behavior more consistent lap after lap.

Specifications

  • Item: Carbon wishbone mount (inside, front/rear)
  • Material: Carbon fiber plate
  • Model Number: SER601404
  • Compatibility: SRX8GTR EC GP SER600077

Install this mount to upgrade the internal wishbone supports on the specified SRX8GTR chassis and monitor component wear and handling consistency through controlled testing.

How durable is the carbon construction under race use?

Carbon fiber plate offers high stiffness-to-weight ratio. When used as the SER601404 internal mount, it resists local flex better than many plastics, but like all composites it should be inspected regularly for chips or delamination after hard impacts.

Will this mount increase maintenance intervals?

The added stiffness can reduce movement-related wear at the mounting interface, which may help extend service intervals for surrounding components, though regular checks remain recommended.

Is the carbon vulnerable to cracking?

While carbon is stiff and light, severe impacts can cause cracks or delamination. Inspect the SER601404 for damage after collisions and replace if structural integrity is compromised.

How should I care for the part to maximise life?

Keep mounting faces clean, avoid over-torquing fasteners, and check for edge damage after hard use. Small repairs are not advised; replace the mount if signs of structural failure appear.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved