CEN Racing Compatible 4-Link Mounting Bracket for CE Chassis - Yokomo C-CQ0305A  [C-CQ0305A]

Yokomo C-CQ0305A 4 link bracket A/B
Price:
NZD$18.61
Brand:
Yokomo
Model:
C-CQ0305A
GTIN:
0639342184415
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Four-Link Mounting Bracket for CEN Racing Trucks

This bracket fastens the suspension link to the front and rear axle housings on CEN Racing monster truck models. It establishes the structural mounting point that maintains alignment between the link and axle during articulation.

Use the bracket when replacing worn parts or returning a truck to original mounting layout. Because the component is structural at the link interface, always verify fitment against the listed chassis codes prior to fitting.

Installation advice: where possible reuse original mounting hardware, confirm screw length and thread engagement, and check that the link pivots freely throughout the suspension travel to avoid any binding or interference.

Compatibility

  • CE-8912 1/12 2WD RTR Monster Truck Fiat Abarth 595
  • CE-8936Y/8937BL 1/12 2WD RTR Monster Truck Suzuki Jimny
  • CE -HL150 1/10 4WD RTR Monster Truck HL-150
  • Supported Chassis CE-8912 / CE-8936Y / CE-8937BL / CE-HL150
Remark :
Due to limited stock availability, please notice that some Yokomo items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Will this bracket tolerate heavy off-road use?

The bracket is intended as a structural mounting part; it holds up under typical off-road stresses when installed correctly. Regularly inspect for cracks or deformation after hard use and replace if any damage appears.

Do I need to alter the links to fit this part?

No special modification of the suspension links is normally required. Fit the bracket and verify that the link pivots freely; if clearance issues occur, check chassis code compatibility and mounting location before trimming any parts.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved