3RACING SAK-C136 Cero Front Upper Ball Cap 5.2mm - Club Racer Fit  [SAK-C136]

3RACING Cero Front Upper Wishborn Ball Cap 5.2mm - SAK-C136
Price:
NZD$6.53
Brand:
3Racing
Model:
SAK-C136
Condition:
Brand New
Write a review

Front Upper Ball Cap for 3RACING Cero SAK-C136

Owners of the Cero series can use the 3RACING SAK-C136 5.2mm ball cap as a straightforward spare or small upgrade. It locates in the front upper wishbone to help preserve suspension geometry and reduce unwanted movement.

Where It Fits

Engineered for the Cero front upper arm, the cap gives a firm seating for the ball stud and helps keep steering precise. The 5.2mm dimension enables quick swaps during service sessions without complicated adjustments.

Fitting Advice

Press the cap in squarely and ensure mating surfaces are clear of grit. After fitting, check steering throw and suspension travel to confirm correct installation before running.

Will this work with aftermarket wishbones?

Compatibility depends on the bore size of the aftermarket arm. If the arm uses a 5.2mm seat, the SAK-C136 should fit; otherwise you may need a different cap or adapter.

Is any lubrication recommended?

A light smear of silicone grease on the ball seat reduces wear and helps keep dirt out without attracting excessive debris.

Can it be used on both smooth and loose surfaces?

Yes, the cap functions the same on different surfaces; just keep it clean and inspect more often after loose or abrasive runs.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved