Cero Sport 64 Graphite Plate Set for 3Racing O-3CK001 by Factory Pro  [FP-O-3CK001]

Price:
NZD$107.57
Brand:
Factory Pro
Model:
FP-O-3CK001
Condition:
Brand New
Write a review

Graphite plate conversion tailored to Cero Sport 64

This Factory Pro aftermarket conversion replaces selected chassis plates on the 3Racing Cero Sport 64 Kit with graphite components to modify flex characteristics and enable more precise tuning at 1/10 touring scale. The upgrade is aimed at hobbyists focused on handling refinement.

Installation notes: the set replaces the stock composite plates with stiffer graphite pieces that alter weight transfer and cornering response. Expect a move toward firmer lateral rigidity; fine-tune spring rates, ride height and sway bar balance to re-establish desired handling. Use this RC accessory only with compatible 3Racing parts.

Specifications

  • Item Graphite conversion kit
  • Material Graphite
  • Model Number O-3CK001
  • Compatibility Only for 3Racing Cero Sport 64 Kit

Compatibility notes

Only for 3Racing Cero Sport 64 Kit.

Install this kit when aiming for a stiffer chassis baseline for circuit work on the 3Racing Cero Sport 64; adjust setup gradually to suit track surface and driving approach.

Will the kit work on older Cero Sport 64 revisions?

Fit depends on the chassis revision; the kit is specified for the 3Racing Cero Sport 64 Kit platform, so confirm your kit revision with the vendor before purchase.

Should I change shock settings after fitting?

Yes. Graphite increases chassis stiffness so you will likely need to soften damping or adjust spring rates to restore balance between front and rear grip.

Is there a break-in period for the graphite plates?

Graphite parts do not need mechanical break-in, but plan a few test runs to evaluate how the new stiffness affects setup and tyre wear before finalising settings.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved