3Racing SAK-C153A Rear Graphite Body Plate for Cero Ultra 2.0 - Tuners Edition  [SAK-C153A]

3Racing Cero Ultra 2.0 Rear Graphite Body Plate - SAK-C153A
Price:
NZD$8.60
Brand:
3Racing
Model:
SAK-C153A
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Fit and Finish for Your Cero Ultra 2.0 with 3Racing SAK-C153A

The 3Racing SAK-C153A rear graphite body plate is produced to suit the Cero Ultra 2.0 chassis. Using quality graphite, this plate increases rear section stiffness while keeping the assembly light, helping drivers dial in rear grip and responsiveness.

Why Graphite Works Well on RC Cars

Graphite offers a good stiffness to weight balance which helps control chassis flex without making the car feel heavy. Adding this rear plate can improve rear-end feedback and make setup changes more repeatable on different surfaces.

Straightforward Fit for the Cero Ultra 2.0

Built to match the factory mounting layout of the Cero Ultra 2.0, the SAK-C153A is a direct-fit upgrade for most users. It suits hobbyists looking to replace worn parts or racers seeking a cleaner baseline for setup work.

Can I use this plate on other Cero variants?

This plate is intended for the Cero Ultra 2.0. Other variants may have different mounting layouts so confirm fit before purchasing.

Will it change handling a lot?

Expect a noticeable reduction in rear flex which can make handling feel firmer and more predictable, especially when cornering hard or under acceleration.

Is any special maintenance required?

Routine checks for tight screws and surface damage are sufficient. Clean the surface of debris and inspect for cracks after heavy use.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved