Compact Multi-Roller Carbon Stay Plate for Mini 4WD M4WD-16_SG by 3Racing  [M4WD-16_SG]

Tamiya Mini 4WD Carbon Multi Roller Flat Plate - 3RACING M4WD-16_SG
Price:
NZD$8.57
Brand:
3Racing
Model:
M4WD-16_SG
Condition:
Brand New
Write a review

Sleek carbon plate for tight multi-roller builds

This aftermarket carbon flat plate is intended for Mini 4WD stay use where a slim mounting solution is required. The M4WD-16_SG offers a narrow profile for fitting multiple small rollers in a confined space while keeping a tidy carbon appearance.

It is compatible with common front, rear, and side stay hole patterns found on Mini 4WD cars and is chosen when builders want a compact roller arrangement without the bulk of thicker stays. Take note of clearance and screw locations when pairing with metal or plastic stay parts.

Practical installation advice: confirm spacer selection and ensure screws engage fully without risking crush at the carbon face. There are no electrical or drivetrain parameters for this passive accessory.

How do I check if this plate will fit my stay?

Measure your stay hole spacing and compare to the plate mounting pattern. The plate follows common Mini 4WD stay layouts but verification is recommended.

What care is needed for thin carbon parts?

Avoid overtightening and use backing spacers where needed. Thin carbon is stiff but can be damaged by concentrated clamping force.

Can I use different roller sizes on this plate?

Small-diameter rollers are typical for tight layouts, but check that shafts and bearings clear the body and do not interfere with nearby components.

Is reinforcement advisable for aggressive track use?

For frequent high-impact running, consider a backup plate or reinforced mounting points to reduce stress on the thin carbon material.

Will this affect handling on the track?

The plate is mainly cosmetic and mounting focused; handling changes are minimal, but correct roller alignment contributes to predictable cornering.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved