A direct-fit aluminum front lower suspension arm designed specifically for the TAMIYA DT-03 chassis. This part is intended as a tougher replacement to reduce wear and deformation compared to stock plastic arms, concentrating on reliable joint geometry and steady steering performance rather than external styling.
Installation follows typical arm replacement steps: remove the factory part, transfer any bearings or locating hardware if required, and attach the aluminum arm with the original screws and pins. After fitting, inspect ball link alignment and toe settings to make sure steering behavior stays as intended.
From a tuning perspective, the stiffer arm reduces unwanted flex and improves repeatability of front-end responses. It is suitable when durability and consistent steering feedback are priorities; pair it with small linkage and shock position adjustments to fine tune the front-end balance.
Select this aluminum lower arm when you need improved durability and dimensional stability that works with DT-03 chassis and supports consistent front suspension behaviour.
Copyright © 2008-2026 rcjaz.co.nz All rights reserved
