Compatible with Tamiya TA-01 Rear Suspension Arms JR-TA111-BK by Jazrider  [JR-TA111-BK]

Price:
NZD$17.93
Brand:
JAZRIDER
Model:
JR-TA111-BK
Condition:
Brand New
Available in shop
Write a review

Machined Rear Suspension Arms for TA-01 Fitment

The JR-TA111-BK assembly swaps the stock TA-01 rear arms for machined aluminum pieces with a black anodized finish. It is supplied as an aftermarket tuning accessory for the Tamiya TA-01 chassis.

On track these arms tend to stiffen the rear mounting area relative to original plastic parts, which can help maintain suspension geometry under load and reduce unwanted flex during aggressive cornering. They are offered as an option for setup refinement rather than a guaranteed lap-time improvement.

Installation summary: the arms are produced to fit TA-01 rear mounting points and slot into the existing suspension layout. Reuse factory screws and ball studs when they are compatible, and double-check clearances around the gearbox and drivetrain. Regular inspections for loose threads and surface wear are recommended.

Tuning advice: moving to aluminum rear arms will change rear behavior, so be prepared to make measured changes to shock length, anti-roll bar settings or toe to find a new balance. Test runs after small adjustments are the best way to dial in chassis response.

Start by removing the stock rear arms, compare ball stud and screw lengths, then install the aluminum arms into the original mounting points. Hand-tighten fasteners first, check alignment, then torque to spec while ensuring no contact with the drivetrain.
Expect a firmer rear feel and reduced flex, which can make the car more responsive but may require suspension length or toe adjustments to regain neutral balance; proceed with incremental changes and test laps.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved