This DC input clip lead is an accessory intended to connect batteries and power packs to the Futaba CR2000 charger via a clip-style removable connection. Its insulated lead construction makes it suitable for workshop bench routines and battery checks on radio-controlled models.
Installation is straightforward: clamp the clip ends to the battery terminals, plug the cable into the CR2000 DC input, and verify polarity before charging. Keep the clips secure during use to avoid intermittent contact. The lead is designed for light bench tasks rather than heavy-duty power applications.
Use this lead to speed up battery setup and on-site checks, enabling quick capacity tests, balancing procedures, or short diagnostic runs while preparing models for running.
Copyright © 2008-2026 rcjaz.co.nz All rights reserved
