Cyclone Compatible Front Swaybar CY-26/F, Machined Aluminium by 3Racing  [CY-26/F]

Adjust front roll with a purpose-built stabilizer

The CY-26/F machined aluminium stabilizer is an aftermarket front anti-roll upgrade that fits Hot Bodies Cyclone Sport and Racing versions. It is intended to replace the factory unit and adjust how the front end resists roll during cornering.

Made from precision-machined aluminium, this stabilizer delivers repeatable stiffness to influence understeer and oversteer balance without touching suspension geometry. It is ideal for 1/10 electric on-road cars where small changes to front roll resistance help tune steering feel and tyre load distribution during practice sessions.

Installation is simple: swap out the stock bar and use the Cyclone's existing mounting points. Only basic hex tools are needed; ensure fasteners are tightened to appropriate torque and check alignment once installed. Confirm full suspension travel and re-check any adjustable link lengths after fitting.

Tuning guidance: increasing front bar stiffness generally reduces chassis roll and sharpens turn-in but may increase understeer at speed. Reducing stiffness adds front compliance and can help with turn bite on lower-grip surfaces. Change settings stepwise and test on consistent track conditions.