Destiny D10034 Front Pivot Pin 3x43mm Precision Upgrade  [DES-D10034]

Destiny DES-D10034 Front Suspension Pivot Pin (3x43mm)
Price:
NZD$5.20
Brand:
Destiny
Model:
DES-D10034
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Precision Front Pivot Pin by Destiny

The Destiny D10034 front suspension pivot pin is intended for modelers who want tighter control over chassis response. At 3x43mm, the pin is sized to suit a range of front-end assemblies and built to resist common wear from regular running. It helps retain consistent geometry through repeated use.

Better Control for Steering and Stability

Small suspension parts make noticeable differences in handling. This Destiny pivot pin offers a precise fit to reduce slop and maintain predictable steering. It is a practical replacement part for tuning sessions and ongoing upkeep of your RC car.

Is this pivot pin compatible with different suspension types?

The 3x43mm sizing suits many common front suspension designs, but compatibility depends on your specific knuckle and arm layout. Compare dimensions before fitting.

What maintenance will prolong the pin life?

Keep pivot areas free of grit, inspect for play, and replace any bent or scored pins. Regular cleaning and proper lubrication help extend service life.

Can I use this pin for competitive tuning?

Yes, it is suitable for tuning and setup work where consistent pivot alignment is needed. Many racers swap to fresh pins when fine-tuning suspension geometry.

Are any special tools required to fit it?

Basic hand tools and a steady workbench are usually enough. Use appropriate pliers or driver bits to avoid damaging the pin or surrounding parts during installation.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved