Destiny D10197 Black Anodised Spacer Set 3x5.5x2.0mm 10pcs  [DES-D10197]

Destiny DES-D10197 3x5.5x2.0mm Aluminum Spacer (Black), 10 pcs
Price:
NZD$12.03
Brand:
Destiny
Model:
DES-D10197
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Small Shims, Big Setup Gains with Destiny D10197

Give your RC a tidy setup boost with Destiny D10197 aluminium spacers. These black anodised rings are 3x5.5x2.0mm and made from lightweight aluminium to combine corrosion resistance with minimal mass. They are ideal for trimming suspension spacing or providing clearance in tight component layouts.

Accurate Shimming for Better Handling

These spacers let you make fine, repeatable changes that improve alignment and balance. The aluminium construction keeps the car nimble while the anodised finish helps the parts hold up through frequent adjustments.

Workshop Friendly Design

Whether preparing for a club meet or doing general servicing, these spacers are simple to install and suit a wide variety of layouts, so you can test configurations quickly and reliably.

How fine are the adjustment steps with these spacers?

At 2.0mm thick each, the spacers give predictable increments when used alone or stacked, letting you tune ride height and geometry in small stages.

Do the black anodised spacers resist corrosion?

The anodised surface offers good protection against wear and corrosion under normal hobby use, helping them last through repeated track sessions.

Is it ok to stack multiple spacers for finer tuning?

Yes, stacking provides incremental spacing changes; just ensure stacked thickness suits your clearance and fastener length.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved