Destiny O10142 3x44.8mm Rear Pivot Pin - Heavy Duty Steel  [DES-O10142]

Destiny DES-O10142 Rear Suspension Pivot Pin (3x44.8mm)
Price:
NZD$13.75
Brand:
Destiny
Model:
DES-O10142
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Keep Suspension True with the Destiny O10142 Pivot

The Destiny O10142 pivot pin is a 3x44.8mm steel pin engineered for long life and precise fitment in compatible rear suspension assemblies. Its heavy duty build helps the suspension retain correct geometry under repeated loads.

Improved Control for Competitive Running

By firmly locating suspension arms, this pivot pin reduces axle wander and increases predictability on bumpy tracks. Consistent articulation improves traction and steering feel during fast laps.

Compatibility Notes and Maintenance

The O10142 suits many 1/10 scale rear layouts where a 3x44.8mm pivot is specified. Periodic inspection and light lubrication will extend service life and keep joints moving smoothly.

How do I confirm this pin fits my rear arms?

Measure your current pivot length and diameter and compare to 3x44.8mm. Also check that the retaining method and surrounding components allow the same pin length to pass through.

Should I replace both pins at once?

Replacing both rear pins together helps maintain balanced wear and handling. If one shows visible wear, the mate is likely similar and is worth swapping to retain symmetry.

Any recommended checks after installation?

After fitting, cycle the suspension through its travel, check for binding, and recheck any set screws or clips. Run a short test to confirm stable handling before full speed sessions.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved