Destiny DES-O10183 Large Urethane Foam Bumper - Tough Front Guard  [DES-O10183]

Destiny DES-O10183 Urethane Foam Bumper, Large
Price:
NZD$10.40
Brand:
Destiny
Model:
DES-O10183
GTIN:
4545137201860
Condition:
Brand New
Available in warehouse
Write a review

Sturdy Urethane Foam Guard for 1/10 On-Road Models

The Destiny DES-O10183 large bumper is constructed from durable urethane foam to protect the front of your RC car. It is intended to absorb impact energy and shield vulnerable components during everyday running and club nights.

Where to Use This Bumper

Designed primarily for 1/10 on-road vehicles, the foam bumper offers reliable cushioning for practice laps and casual circuits. Its profile is tuned to reduce force transfer to the chassis on typical frontal hits.

Installation Notes and Fit Compatibility

Installation is straightforward for most on-road chassis with common bumper mounts. Minimal trimming may be required for some bodies, so check fit before final mounting to ensure clean alignment.

Is trimming usually needed to fit different body shells?

Some bodies may need light trimming around the bumper edges; test-fit the bumper and mark any contact points before cutting.

Will it affect handling or aerodynamics?

The bumper is low profile and should not noticeably change handling or aero on most touring car setups, though heavy bumper mass can slightly alter front-end feel.

Can I paint or finish the foam?

Urethane foam accepts some flexible coatings and paints, but test a small area first and use products designed for soft plastics to avoid degradation.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved