The Yokomo SD-LW22L extension cord offers a 150mm fixed lead with a 2P-to-2P connector suited to RC-scale LED installations and small accessory connections. Its purpose is to bridge gaps between LED boards or light units and the receiver or power distribution point while leaving factory connectors intact.
Because this is a passive wiring accessory rather than an electronic module, it allows relocation of LED elements without re-soldering. When installing, route the lead clear of suspension and steering components, avoid tight bends, and anchor the cable with small ties to prevent rubbing against the chassis during use.
Ideal for modest reach requirements for LED modules or compact sensors, the extension should be used with attention to connector orientation to avoid reversed polarity. The cord is compatible with the DP-series chassis shown in the compatibility list below.
Copyright © 2008-2026 rcjaz.co.nz All rights reserved
