DP7C Aluminium Front Upper Arm Mount Upgrade - YOKD082 by Yokomo  [YOKD082]

Overview of the DP7C front upper arm mount

This aluminium front upper arm mount is an RC-scale replacement intended for DP7C chassis use. It gives a stiffer mounting point for the front upper arm and affects suspension geometry, helping to sharpen steering response during setup.

Designed to replace the stock mount, the part works with the DP7C front suspension arrangement and allows small, precise changes to upper arm height and pivot location. Those micro-adjustments change camber and roll center, which are crucial when tuning balance for drift driving.

Installation may require removing either the front bulkhead or the shock tower depending on your chassis version, and the mount should be fastened using the original mounting hardware. Always check pivot alignment and confirm there is no binding across the suspension range before final tightening. Regularly inspect the mount and mounting screws for wear.

Use this component to stabilise front-end behavior when adjusting camber and roll-center on DP7C-based drift cars, confirming compatibility with your front arm and damper setup before use.