DP-DPR Left Steering Bell Crank - Aluminum D-127L for DP-DPR by Yokomo  [D-127L]

Left aluminum bell crank built for DPR chassis

This component is the left-side aluminum steering bell crank intended for use on the Drift Package DPR chassis family. It replaces the left steering bell crank in the steering linkage between the servo and tie rods on DPR-series vehicles.

The part is compatible only with DP-DPR chassis and the specifically listed variants DP-DPMS and DP-DPRA. Confirm compatibility and measure against the original part to ensure a correct fit on your model before completing assembly.

Fitting is simple for those comfortable with DPR steering systems: remove the original left bell crank, check alignment of the servo output arm and steering linkage, then install the D-127L in the same orientation as the OEM piece. Examine ball bearings and fasteners for wear and tighten with appropriate hex keys to the recommended torque.

In tuning or maintenance scenarios the D-127L serves as a straightforward left-side replacement that supports repeatable geometry checks. It is specified as a service or repair component rather than a claimed performance upgrade.