DT-03 Steering C Hub Compatible with TAMIYA, Red Anodized Aluminum - JR-DT304-RD by Jazrider  [JR-DT304-RD]

Tamiya DT-03 Aluminum C Hub (Red)
Price:
NZD$17.51
Brand:
JAZRIDER
Model:
JR-DT304-RD
Condition:
Brand New
Available in shop
Write a review

Precision C Hub for DT-03

This red anodized aluminum C hub is crafted as an aftermarket replacement for the DT-03 steering knuckle region and gives a firmer interface for steering linkages and uprights. The added stiffness helps keep alignment consistent and reduces flex when the chassis is under load.

Intended for 1/10 scale hobby electric cars, the component focuses on tuning and robust service life rather than altering core suspension geometry. Install by removing the original hub, transferring any bearings or bushings, then confirm steering travel and suspension movement across the full range before using the vehicle.

Will this improve steering precision?

By reducing flex at the hub mounting point, steering response typically feels firmer and more predictable, aiding fine tuning of toe and ackerman settings.

Is additional setup needed after fitting?

Check and, if needed, re-set toe and steering end points after installation since the firmer hub can slightly alter perceived steering feel though not fundamental geometry.

Are special tools required to fit this hub?

Standard hobby tools are sufficient; use a press or suitable drivers for bearings and ensure fasteners are tightened evenly to avoid preload on steering components.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved