JAZRIDER JR-DT308-BK 2pc Steel Drive Shafts - Robust upgrade for Tamiya DT02/DT03/TT02B  [JR-DT308-BK]

Tamiya DT02/DT03/TT02B Steel Drive Shaft (2pcs)
Price:
NZD$21.88
Brand:
JAZRIDER
Model:
JR-DT308-BK
Condition:
Brand New
Available in warehouse
Write a review

Robust steel drive shafts for Tamiya models

For pilots wanting a tougher drivetrain on Tamiya DT02, DT03 or TT02B cars, the JAZRIDER JR-DT308-BK steel shafts are a reliable swap. They offer greater longevity than original plastic shafts for everyday park and track use.

Compatibility notes

These shafts are intended to pair with Tamiya plastic cup joints and match the standard layout on the specified models. They will not work with Tamiya 53790, so confirm your joint type before purchasing.

Installation pointers

Fit the shafts carefully and make sure they are held firmly in place to prevent movement while running. Routine checks after sessions will help maintain drivetrain performance and catch wear early.

Can I use these on a converted model?

They are made for the DT02, DT03 and TT02B layouts. If your conversion keeps the same cup joint and axle spacing they may fit, but measure carefully before fitting.

Will they need setup changes?

No major setup changes are typically required. Install them and verify driveline alignment and fastener security as part of the initial check.

Are they suitable for off-road use?

These steel shafts are tougher than stock, making them better for mixed-surface use. Always inspect after rough runs and remove trapped stones or grit.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved