DT-04 Aftermarket Rear Hub Stub Carriers 7075-T6 Oversize Bearings DT4022 by GPM  [DT4022]

Machined rear hub stubs for DT-04

This upgrade swaps the stock rear hub stub carriers on TAMIYA DT-04 RC FIGHTER NXGEN kits for precision-machined 7075-T6 aluminium carriers fitted for oversized bearings, cutting endplay and improving steering accuracy at the wheel hub for 1/10 scale rigs.

Available in anodized finish options, the carriers include oversize bearings chosen for better alignment and extended service life versus the factory inserts. Small hardware is pre-installed to speed up the changeover process.

Fitment tips: take off the original rear hub stub carriers, move any required seals or spacers across, press in the supplied oversized bearings, add the stainless washers and tighten fasteners using medium-strength thread locker to prevent run-time loosening.

Designed to improve hub support and bearing placement, these carriers sharpen the rear-end steering feel while leaving suspension geometry and driveline components unchanged.