DZ140 / DZ160 Rear Back Plate Replacement YSF4128A for YS Engine  [YSF4128A]

YS ENGINE BACK PLATE ASSEMBLY DZ140 DZ160 #F4128A
Price:
NZD$47.01
Brand:
YS Engine
Model:
YSF4128A
GTIN:
4560105739435
Condition:
Brand New
Write a review

Rear case back plate for DZ-series engines

The YS Engine YSF4128A back plate assembly is a scale replacement designed specifically for the DZ140 and DZ160 engine ranges. It forms the rear closure of the crankcase and locates rear-mounted components during disassembly and reassembly of the engine.

This component is intended for model-scale engine servicing and tuning. During replacement, inspect the mating surfaces for wear, check gasket condition, and ensure fastener threads are clean so the assembly seals and aligns correctly. The part supports common teardown and rebuild practices used in nitro engine servicing.

Compatibility is limited to the DZ140 and DZ160 models listed. Prior to fitting, verify your engine model and compare the locating features to the original back plate to avoid incorrect fitment. The item is offered as a direct spare and integrates with the existing YS Engine mounting and sealing configuration for these engines.

Specifications

  • Item: YS ENGINE BACK PLATE ASSEMBLY
  • Model Number: YSF4128A
  • Material: Not specified
  • Compatibility: DZ140, DZ160

Fit this back plate assembly when servicing DZ140 or DZ160 engines to reestablish rear case alignment and sealing; always check part details before installation and follow standard rebuild routines.

Does YSF4128A require modifications to fit a DZ160?

The part is listed for both DZ140 and DZ160. Still, carry out a visual check of mounting points and locating dowels so no machining or modifications are needed.

Are material details available for assessing durability?

Material is not provided in the product information, so treat durability as unspecified until clarified by the supplier.

Is this intended as a service spare or an upgrade part?

This item is presented as a replacement assembly to restore original function rather than a performance upgrade.

Will seals or gaskets be included in the package?

The description does not mention included seals or gaskets, so assume they are not supplied unless the vendor states otherwise.

What pre-install checks should I perform for correct alignment?

Confirm that locating features match, clean mating faces, replace any worn gasket material, and tighten bolts progressively to maintain alignment.

How do I confirm the part number before ordering?

Verify the model number YSF4128A against your engine service manual or the original part stamp and compare the bolt pattern visually to ensure correct selection.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved