EDS 120115 Ball Driver Hex Wrench 1.5mm Ball-End 120mm  [EDS-120115]

EDS 120115 - Ball Driver Hex Wrench 1.5 X 120mm
Price:
NZD$16.54
Brand:
EDS
Model:
EDS-120115
Condition:
Brand New
Write a review

EDS 120115 Ball Driver Built for Tight Spots

The EDS 120115 Ball Driver Hex Wrench provides accurate handling for 1.5mm hex screws found across many radio control models. Its design focuses on control and access when working in cramped areas of the model.

Slim Reach and Comfortable Hold

The 120mm shaft extends into narrow cavities while the handle is shaped for steady torque and less hand fatigue. The ball end allows slight angle adjustments so you can reach screws that are not perfectly aligned with the driver.

Useful Across Model Types

From short-course trucks to scale crawlers the EDS 120115 is adaptable for tightening links and adjusting gearsets. It is a lightweight, reliable tool to add to any toolkit for everyday maintenance and setup checks.

Will this work on aircraft and cars?

Yes, any model that uses 1.5mm hex screws can use this driver, including small planes and many ground vehicles.

How can I avoid stripping tiny screws?

Use steady pressure, ensure the ball tip fully seats in the screw, and avoid excessive force. The ball end helps maintain contact when angled.

Is the shaft rigid enough for firm torque?

The 120mm shaft balances reach with stiffness suitable for routine tightening and small adjustments. For very high torque you should use a shorter driver.

Any recommended storage to protect the tip?

Keep it in a foam tool roll or separate compartment to stop the ball tip from striking other tools and losing its profile.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved