EDS 120130 3.0mm Ball Driver Hex Wrench 120mm Workshop Tool  [EDS-120130]

Sharp Access with the EDS 3.0mm Ball Tip

The EDS 120130 Ball Driver Hex Wrench is built for model builders and racers who need clean, repeatable turns. Constructed from treated EDS spring steel, this tool resists deformation and keeps the hex profile accurate over time.

Designed for Tight Spaces

The ball end on the 3.0mm driver provides angled access to screws tucked into narrow sections of an RC model. The 120mm length offers useful reach to get into deeper areas without losing hand control.

Practical EDS Engineering

EDS tools focus on dependable performance rather than flash. This ball driver is a straightforward, solid choice for adjusting linkages, servo mounts and other routine work on a variety of models.